EF Logo

Cummins · Air handling - SPN 102 FMI 3

Cummins Fault Code 122

Intake manifold pressure sensor signal voltage high

What does Cummins code 122 mean?

The ECM sees the intake manifold pressure sensor signal above its normal voltage band. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: manifold pressure should match barometric pressure; a reading near the top of its scale confirms a high-voltage fault.

FaultCheck122Cummins · Air handling - SPN 102 FMI 3

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: manifold pressure should match barometric pressure; a reading near the top of its scale confirms a high-voltage fault

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Sensor signal wire rubbed through against the intake manifold bracket and touching the 5 V reference
  • Open return wire between the boost sensor and the ECM, so the signal climbs to reference
  • Pressure sensor failed high internally after oil or moisture got into the port
  • Connector shared by the intake temperature element corroded, lifting the signal

How it failed

You'll notice: The engine runs on a fixed boost map, so it feels flat under load, smokes more and may be limited in power.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Intake manifold pressure and temperature sensors

1 other code on this part is also shorted high (153). When they show together, start at the wiring and connector they share.

Show the other 14 codes
All 23 Intake manifold pressure and temperature sensors codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 122 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 102, FMI 3); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.