EF Logo

Volvo/Mack · MID 128 engine ECU - module, data link and power

Volvo/Mack Fault Code MID 128 SID 254 FMI 12

Engine ECU self-test failure

What does Volvo/Mack code MID 128 SID 254 FMI 12 mean?

The engine ECM failed its own self-test. Mack lists the control module itself as the cause, so the fault is internal. Urgency: stop now - shut down and fix before working on. Check first: check power, ground and ignition feeds at the ECM connector for dropouts.

FaultStopMID 128SID 254FMI 12Volvo/Mack · MID 128 engine ECU - module, data link and power
MID 128
Which control unit reports it
SID 254
Component at fault
FMI 12
Bad intelligent device or component

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check power, ground and ignition feeds at the ECM connector for dropouts

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Internal failure of the engine control module
  • Water or corrosion damage inside the ECM
  • Supply voltage problem at the module

How it failed

You'll notice: Red stop lamp lit and the engine will not start because the ECM cannot run its own checks.

Part or controllerRead from FMI 12: bad intelligent device or component

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 254 FMI 12 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.