Volvo/Mack · MID 128 engine ECU - module, data link and power
Volvo/Mack Fault Code MID 128 SID 253 FMI 2
Engine ECU calibration memory checksum error
What does Volvo/Mack code MID 128 SID 253 FMI 2 mean?
The calibration memory in the engine control module has a checksum error, so engine parameters cannot be trusted. Urgency: stop now - shut down and fix before working on. Check first: check battery voltage and ground connections before touching the ECM.
- MID 128
- Which control unit reports it
- SID 253
- Component at fault
- FMI 2
- Erratic or incorrect data
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check battery voltage and ground connections before touching the ECM
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Corrupted calibration data in the ECM
- ECM software fault
- Power interruption while the ECM was writing data
How it failed
You'll notice: Red stop lamp lights and the engine will not start because the calibration data cannot be trusted.
Erratic or implausibleRead from FMI 2: erratic or incorrect data
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 128 engine ECU - module, data link and power
- MID 128 SID 240 FMI 2Engine ECU program memory checksum error
- MID 128 SID 39 FMI 3Starter relay output shorted high
- MID 128 SID 39 FMI 5Starter relay circuit open
- MID 128 PID 158 FMI 1ECM battery voltage too low
- MID 128 PID 158 FMI 3ECM battery voltage too high
- MID 128 PSID 161 FMI 2Vehicle identification number (VIN) missing
- MID 128 PSID 201 FMI 9Message from instrument cluster missing
- MID 128 PSID 229 FMI 2SAE J1939 data link 2 circuit shorted or open
Related on Equipments Finder
Source
This source lists MID 128 SID 253 FMI 2 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
