EF Logo

John Deere · Main controller (MCZ) - pressure sensors

John Deere Fault Code MCZ 11302.04

Boom up pressure sensor (B30) signal low

What does John Deere code MCZ 11302.04 mean?

The main controller reads the boom up pressure sensor (B30) on the boom raise circuit as low. The control logic that uses this pressure becomes unreliable, so the machine may feel weak or jerky. Urgency: check soon - the machine may derate or limit a function. Check first: check supply and ground voltage at the unplugged B30 connector with the key on.

FaultCheckMCZ11302.04John Deere · Main controller (MCZ) - pressure sensors
MCZ
Which controller reports it
11302
What is at fault
.04
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check supply and ground voltage at the unplugged B30 connector with the key on

Then 5 more checks
Code shows hereFAULTMCZ11302.04

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 6 done

Causes

  • B30 signal wire open from chafing along the boom
  • B30 signal wire shorted to the machine frame
  • No 5 V at B30 because of a damaged supply wire
  • B30 failed low

How it failed

You'll notice: Boom up pressure reads zero, so the MCZ has no feedback on boom raise load.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Boom, arm and bucket pressure sensors

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11302.04 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.