EF Logo

JCB · Engine ECU (Dieselmax / Ecomax) - electrical

JCB Fault Code P0685

ECU power relay control circuit open

What does JCB code P0685 mean?

The relay that powers the engine ECU is not being controlled properly, so ECU power may drop out. Urgency: check soon - the machine may derate or limit a function. Check first: swap the relay with a known good one of the same type.

FaultCheckP0685JCB · Engine ECU (Dieselmax / Ecomax) - electrical

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Swap the relay with a known good one of the same type

Then 5 more checks
Code shows hereFAULTP0685

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • ECU main power relay failed, or its contacts burnt
  • Relay control wire open between the ECU and the relay
  • Corroded relay socket or loose terminals
  • Blown fuse in the ECU supply
1 more cause
  • Poor battery or earth connection to the relay

How it failed

You'll notice: The ECU may lose power as soon as the key is on, or cut out unexpectedly while running.

Open circuitRead from how the source describes the code

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: ECU power relay, 5 V supply, injector power supply and starter circuit

1 other code on this part is also open circuit (P20EA-72). When they show together, start at the wiring and connector they share.

Show the other 17 codes
All 26 ECU power relay, 5 V supply, injector power supply and starter circuit codes on one page

Source

Partao JCB fault code P0685 page

This source lists P0685 and its meaning. The guidance on this page is general, not taken from it.

The source covers: 2CX, 3CX, 4CX, 214-217, 526, 533-105, 540, TM320, Fastrac.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.