EF Logo

J1939 · Fuel system

SPN 656 Fault Code

Engine injector, cylinder 6

What does SPN 656 mean?

The ECM drive circuit and injector solenoid for cylinder 6. The ECM fires it for each injection event and checks the circuit for opens, shorts and response. How urgent it is depends on the FMI after SPN 656 - pick it below. Check first: unplug the cylinder 6 injector at the valve cover and measure the coil across its two pins, comparing with a healthy cylinder.

FaultActiveSPN 656FMI --J1939 engine ECU
SPN 656
Engine injector, cylinder 6
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 656 - pick it below.

What should I check first?

Unplug the cylinder 6 injector at the valve cover and measure the coil across its two pins, comparing with a healthy cylinder

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 656?

You'll notice: Cylinder 6 (the rear cylinder at the flywheel end) is not being fired properly by its injector.

Find the number shown after SPN 656 on your display. FMI 5 has its own page with causes and checks.

  • 3SPN 656 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, PACCAR MX-13, Volvo D13
  • 4SPN 656 FMI 4: The ECM found cylinder 6 injector needle control valve operating below its minimum, or the circuit shorted to groundShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
  • 5SPN 656 FMI 5: Current is below normal, or the circuit is openOpen circuitCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 6SPN 656 FMI 6: Cylinder 6 injector circuit is shorted, either to another injector pin or within the valveShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
  • 7SPN 656 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerCummins ISX15, Mack MP8, Mack MP7, Volvo D13
  • 8SPN 656 FMI 8: Abnormal frequency, pulse width or period of the signalErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 13SPN 656 FMI 13: The value is out of calibrationPart or controllerMack MP8, Mack MP7, Volvo D13
  • 31SPN 656 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionMack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

How urgent SPN 656 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Needle control valve sticking or the injector worn on cylinder 6, so it opens late or not at all
  • Dirty or water-contaminated fuel scoring the cylinder 6 injector valve
  • ECM driver circuit for cylinder 6 failed, which is rare and only after the injector and wiring are cleared
  • Cylinder 6 injector wiring rubbed or heat-damaged at the rear end of the valve cover, close to the flywheel housing
1 more cause
  • Oil or heat from the rear of the engine degrading the cylinder 6 connector seal after rear-of-engine work

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list names SPN 656 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.