J1939 · Fuel system
SPN 5571 Fault Code
Engine common-rail fuel pressure relief valve
What does SPN 5571 mean?
The valve that opens to dump rail pressure if it climbs above a safe limit. The ECM monitors it, through rail behaviour, for sticking or leakage. How urgent it is depends on the FMI after SPN 5571 - pick it below. Check first: read rail pressure against the commanded pressure at cranking and idle.
- SPN 5571
- Engine common-rail fuel pressure relief valve
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5571 - pick it below.
What should I check first?
Read rail pressure against the commanded pressure at cranking and idle
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5571?
You'll notice: The high-pressure relief valve on the common rail is not working as the ECM expects, so rail pressure can be too low, too high or out of control.
Find the number shown after SPN 5571 on your display.
- 0SPN 5571 FMI 0: Value is above the normal range, most severe levelReal conditionCummins ISX15
- 2SPN 5571 FMI 2: A malfunction was detected while checking the pressure relief valveErratic or implausiblePACCAR MX-13
- 5SPN 5571 FMI 5: Pressure relief valve circuit is openOpen circuitPACCAR MX-13
- 6SPN 5571 FMI 6: Pressure relief valve circuit is shorted to ground or reads lowShorted lowPACCAR MX-13
- 7SPN 5571 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerCummins ISX15
- 15SPN 5571 FMI 15: Pressure relief valve current is too highReal conditionPACCAR MX-13
- 16SPN 5571 FMI 16: Rail pressure control is incorrect, moderately severeReal conditionPACCAR MX-13
- 17SPN 5571 FMI 17: Pressure relief valve current is too low or the circuit is openReal conditionPACCAR MX-13
- 18SPN 5571 FMI 18: Rail pressure control is incorrect, moderately severeReal conditionPACCAR MX-13
- 20SPN 5571 FMI 20: Pressure relief valve current is too highErratic or implausiblePACCAR MX-13
- 21SPN 5571 FMI 21: Pressure relief valve current is too lowErratic or implausiblePACCAR MX-13
Checks
0 of 5 done
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
How urgent SPN 5571 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Relief valve circuit open or shorted: broken wire, pin backed out or chafed harness at the rail
- Relief valve stuck open, leaking rail pressure back to the tank and keeping pressure low
- Relief valve stuck closed, letting pressure rise above the target
- Rail pressure sensor reading wrongly, so the ECM commands the valve incorrectly
Other Fuel system codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5571 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
