EF Logo

J1939 · Aftertreatment - DPF

SPN 4766 Fault Code

Aftertreatment exhaust gas temperature before DPF

What does SPN 4766 mean?

Exhaust temperature measured ahead of the particulate filter. The ECM uses it to control regeneration and to protect the filter. How urgent it is depends on the FMI after SPN 4766 - pick it below. Check first: compare the temperature with the DOC and DPF temperatures during a parked regeneration.

FaultActiveSPN 4766FMI --J1939 engine ECU
SPN 4766
Aftertreatment exhaust gas temperature before DPF
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4766 - pick it below.

What should I check first?

Compare the temperature with the DOC and DPF temperatures during a parked regeneration

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4766?

You'll notice: The exhaust temperature before the DPF is misread or really too high, so the ECM may block regeneration or cut power to protect the filter.

Find the number shown after SPN 4766 on your display.

  • 2SPN 4766 FMI 2: Data is erratic, intermittent or incorrectErratic or implausiblePACCAR MX-13
  • 3SPN 4766 FMI 3: Exhaust temperature sensor before the DPF reads highShorted highPACCAR MX-13
  • 4SPN 4766 FMI 4: Exhaust temperature sensor before the DPF reads lowShorted lowPACCAR MX-13
  • 15SPN 4766 FMI 15: Exhaust temperature before the DPF is too high, least severeReal conditionPACCAR MX-13
  • 16SPN 4766 FMI 16: Exhaust temperature before or after the DPF, or at the DOC, is too high, moderately severeReal conditionPACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4766 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Sensor circuit fault: wiring open, shorted or heat-damaged near the DOC outlet
  • Real over-temperature from a doser fault or a regeneration that ran too hot
  • Sensor loose in its boss, with exhaust leaking past and distorting the reading
  • Sensor aged and drifting, so its reading no longer matches the real gas temperature

Source

PACCAR MX-13 2013-2016 fault codes list (Diesel Laptops)

This list names SPN 4766 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: PACCAR MX-13; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.