J1939 · Fuel system
SPN 1075 Fault Code
Engine electric fuel lift pump
What does SPN 1075 mean?
The electric pump that moves fuel from the tank to the engine at low pressure, switched by the ECM. The ECM watches its circuit and the resulting supply pressure. How urgent it is depends on the FMI after SPN 1075 - pick it below. Check first: listen for the pump to run for a few seconds when the key goes on, and read its command in the service tool.
- SPN 1075
- Engine electric fuel lift pump
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 1075 - pick it below.
What should I check first?
Listen for the pump to run for a few seconds when the key goes on, and read its command in the service tool
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 1075?
You'll notice: The electric fuel lift pump is not running as commanded, so the engine may be starved of fuel at start or under load, giving hard starting, stalling and a lamp.
Find the number shown after SPN 1075 on your display.
- 3SPN 1075 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15
- 4SPN 1075 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15
Checks
0 of 5 done
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
How urgent SPN 1075 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Pump circuit open or shorted: blown fuse, burned relay contacts, or a chafed supply wire near the tank
- Lift pump seized or worn, so it draws too much or too little current
- Relay or driver in the ECM not switching the pump, from a loose ground or corroded connector
- Fuel line or filter blockage that loads the pump and trips the circuit
Other Fuel system codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 1075 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
