Genie · Engine faults (Deutz TD 2.9, SPN/FMI)
Genie Fault Code SPN 100 / FMI 1
Low oil pressure
What does Genie code SPN 100 / FMI 1 mean?
The engine oil pressure is below the warning or shut-off threshold. The engine derates or shuts down and the oil pressure lamp comes on. Urgency: stop now - shut down and fix before working on. Check first: check the oil level on the dipstick and top up with the specified oil if low; do not run the engine if the level is below the mark.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check the oil level on the dipstick and top up with the specified oil if low; do not run the engine if the level is below the mark.
Then 4 more checksWhere this code shows
Scissors: read the code on the platform LED display or the ground control LCD.
Checks
0 of 5 done
Causes
- Low oil level or wrong oil grade
- Worn oil pump or bearings
- Oil pressure sensor or wiring fault
- Blocked oil filter or leaking oil cooler
How it failed
You'll notice: The engine derates or shuts down and the oil pressure lamp lights because oil pressure is below the threshold.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Deutz engine faults (SPN/FMI)
3 other codes on this part are also real condition (SPN 94 / FMI 1, SPN 110 / FMI 0, SPN 111 / FMI 1). When they show together, start at the wiring and connector they share.
- SPN 94 / FMI 1Low fuel pressureReal conditionStop now
- SPN 97 / FMI 12Water in fuel prefilterPart or controllerCheck soon
- SPN 100 / FMI 1Low oil pressureReal conditionStop now
- SPN 110 / FMI 0High coolant temperatureReal conditionStop now
- SPN 111 / FMI 1Coolant level too lowReal conditionStop now
- SPN 157 / FMI 3Rail pressure sensor signal highShorted highCheck soon
- SPN 190 / FMI 12Crankshaft speed sensor: no signalPart or controllerStop now
- SPN 523633 / FMI 11NOx conversion rate insufficientLost messageCheck soon
- SPN 524025 / FMI 14Particulate filter regeneration not successfulOtherCheck soon
Related on Equipments Finder
Source
Genie GTH-5519 (Deutz Tier 4i) Service and Repair Manual 1272852, Section 4 Fault Codes
This source lists SPN 100 / FMI 1 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Genie GTH-5519 telehandler, Deutz Tier 4i (from serial GTH5514B-101).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
