Genie · Engine faults (Deutz TD 2.9, SPN/FMI)
Genie Fault Code SPN 110 / FMI 0
High coolant temperature
What does Genie code SPN 110 / FMI 0 mean?
Coolant temperature is above the warning or shut-off threshold. The engine derates and may shut down, and the coolant temperature warning lamp comes on. Urgency: stop now - shut down and fix before working on. Check first: check the coolant level when the engine is cool and look for leaks at hoses, radiator and water pump.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check the coolant level when the engine is cool and look for leaks at hoses, radiator and water pump.
Then 4 more checksWhere this code shows
Scissors: read the code on the platform LED display or the ground control LCD.
Checks
0 of 5 done
Causes
- Low coolant level or a leak
- Blocked radiator or charge air cooler fins
- Fan drive or belt fault
- Thermostat stuck closed
How it failed
You'll notice: The engine derates and may shut down, and the coolant temperature lamp comes on.
Real conditionRead from FMI 0: data above normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Deutz engine faults (SPN/FMI)
3 other codes on this part are also real condition (SPN 94 / FMI 1, SPN 100 / FMI 1, SPN 111 / FMI 1). When they show together, start at the wiring and connector they share.
- SPN 94 / FMI 1Low fuel pressureReal conditionStop now
- SPN 97 / FMI 12Water in fuel prefilterPart or controllerCheck soon
- SPN 100 / FMI 1Low oil pressureReal conditionStop now
- SPN 110 / FMI 0High coolant temperatureReal conditionStop now
- SPN 111 / FMI 1Coolant level too lowReal conditionStop now
- SPN 157 / FMI 3Rail pressure sensor signal highShorted highCheck soon
- SPN 190 / FMI 12Crankshaft speed sensor: no signalPart or controllerStop now
- SPN 523633 / FMI 11NOx conversion rate insufficientLost messageCheck soon
- SPN 524025 / FMI 14Particulate filter regeneration not successfulOtherCheck soon
Related on Equipments Finder
Source
Genie GTH-5519 (Deutz Tier 4i) Service and Repair Manual 1272852, Section 4 Fault Codes
This source lists SPN 110 / FMI 0 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Genie GTH-5519 telehandler, Deutz Tier 4i (from serial GTH5514B-101).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
