EF Logo

Genie · Battery charger codes

Genie Fault Code E‑0‑0‑2

Charger: low battery voltage before charge

What does Genie code E-0-0-2 mean?

The battery voltage is too low for the charger to start a charge. The code clears itself once the voltage rises above the minimum threshold. Urgency: check soon - the machine may derate or limit a function. Check first: measure the pack voltage and each battery's voltage; a weak battery will read well below its neighbours.

FaultCheckE-0-0-2Genie · Battery charger codes

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the pack voltage and each battery's voltage; a weak battery will read well below its neighbours.

Then 3 more checks
Code shows hereFAULTE-0-0-2

Where this code shows

Scissors: read the code on the platform LED display or the ground control LCD.

Checks

0 of 4 done

Causes

  • Deeply discharged pack
  • Bad cell or battery connection
  • Loose or corroded battery cables
  • Charger sensing wire fault

How it failed

You'll notice: The charger will not begin a charge because the pack voltage is too low; it starts once voltage rises above the minimum threshold.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Charger battery, supply, temperature and connection errors

Source

Genie GS-1530/1930/2032/2632 etc. Service and Repair Manual 1272217GT (Rev E1), Section 4 Diagnostics

This source lists E-0-0-2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Genie GS slab scissors with the on-board charger.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.