Cat · Power supply
Cat Fault Code CID 168 FMI 02
Electrical system voltage erratic
What does Cat code CID 168 FMI 02 mean?
System voltage is jumping or reading incorrectly. The manual blames dirty or loose connections, the engine wiring harness or the fuse module 2 cable, so treat it as an intermittent supply problem. Urgency: check soon - the machine may derate or limit a function. Check first: wiggle-test the battery cables and ground straps while watching battery voltage on Cat ET.
- CID 168
- Which component is at fault
- FMI 02
- Erratic or incorrect data
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Wiggle-test the battery cables and ground straps while watching battery voltage on Cat ET.
Then 4 more checksWhere this code shows
Turn the key on and check the cluster or monitor for a warning lamp.
Checks
0 of 5 done
Causes
- Dirty or corroded connections in the supply path
- Faulty engine wiring harness
- Fuse module 2 cable with a loose terminal
How it failed
You'll notice: The machine may cut out or the monitor may restart now and then, usually over bumps or when the harness moves, with no fixed pattern.
Erratic or implausibleRead from FMI 2: erratic or incorrect data
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, key switch and starting
3 other codes on this part are also erratic or implausible (E875, E876, CID 1834 FMI 02). When they show together, start at the wiring and connector they share.
- CID 168 FMI 00Electrical system voltage highReal conditionStop now
- CID 168 FMI 01Electrical system voltage lowReal conditionCheck soon
- CID 168 FMI 02Electrical system voltage erraticErratic or implausibleCheck soon
- CID 168 FMI 04Powertrain power supply voltage lowShorted lowCheck soon
- CID 444 FMI 03Start relay voltage highShorted highCheck soon
- E875Low system voltageErratic or implausibleCheck soon
- E876High system voltageErratic or implausibleCheck soon
- CID 1834 FMI 02Ignition key switch circuit erraticErratic or implausibleCheck soon
- CID 2246 FMI 05Glow plug start aid relay current lowOpen circuitCheck soon
- CID 2417 FMI 05Start aid (ether) solenoid current lowOpen circuitCheck soon
Related on Equipments Finder
Source
This source lists CID 168 FMI 02 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
