EF Logo

Cat · Power supply

Cat Fault Code CID 168 FMI 01

Electrical system voltage low

What does Cat code CID 168 FMI 01 mean?

The engine ECM saw system voltage fall below the normal 24 V range. Urgency: check soon - the machine may derate or limit a function. Check first: confirm 168-1 is active on Cat ET with the engine running and note the battery voltage shown.

FaultCheckCID 168FMI 01Cat · Power supply
CID 168
Which component is at fault
FMI 01
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Confirm 168-1 is active on Cat ET with the engine running and note the battery voltage shown.

Then 4 more checks
Code shows hereFAULTCID 168FMI 01

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • High resistance in the engine or lower cab wiring harness
  • Dirty, corroded or loose ground terminals
  • Poor connection at the main fuse
  • Weak batteries or poor alternator output

How it failed

You'll notice: Lamps dim and the engine may stall or restart, and the display can reset while cranking or under load.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: System voltage, key switch and starting

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 168 FMI 01)

This source lists CID 168 FMI 01 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.