Bobcat · Engine controls
Bobcat Fault Code M2899
Throttle secondary sensor calibration required
What does Bobcat code M2899 mean?
The controller needs the throttle sensors calibrated. It typically shows after replacing the throttle sensor, controller or software. Urgency: check soon - the machine may derate or limit a function. Check first: review recent work on the throttle assembly, since moving a sensor changes its calibration.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Review recent work on the throttle assembly, since moving a sensor changes its calibration
Then 4 more checksWhere this code shows
On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.
Checks
0 of 5 done
Causes
- Calibration data lost
- Throttle sensor replaced or moved without calibration
- Throttle linkage out of position
- Controller replaced or reprogrammed
How it failed
You'll notice: The controller wants the throttle sensors calibrated.
Part or controllerRead from how the source describes the code
The controller reports a part, module or its software as faulty or not responding.
- Meter test
- Check power and ground at the module connector with the key on, then its fuses.
- Good result
- Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Throttle sensors, throttle controller and accelerator pedal
4 other codes on this part are also part or controller (P0225-54, M3223, M3228, M3299). When they show together, start at the wiring and connector they share.
- M2721Throttle primary sensor out of range highOtherCheck soon
- M2722Throttle primary sensor out of range lowOtherCheck soon
- M2821Throttle secondary sensor out of range highOtherCheck soon
- M2822Throttle secondary sensor out of range lowOtherCheck soon
- M2899Throttle secondary sensor calibration requiredPart or controllerCheck soon
- M3223Throttle controller not calibratedPart or controllerCheck soon
- M3228Throttle controller failurePart or controllerCheck soon
- M3299Throttle controller calibration in processPart or controllerCheck soon
- VS5003-03Accel pedal sensor, voltage above normalShorted highCheck soon
Show the other 5 codesHide the other codes
- VAL002-05Accel. pedal switch, current below normalOpen circuitCheck soon
- VAL002-06Accel. pedal switch, current above normalShorted lowCheck soon
- P0225-54Throttle pedal position sensor calibration requiredPart or controllerCheck soon
- U1015-62Throttle encoder signal failureOtherCheck soon
- VS5003-04Accel pedal sensor, voltage below normalShorted lowCheck soon
Related on Equipments Finder
Source
Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)
This source lists M2899 and its meaning. The guidance on this page is general, not taken from it.
The source covers: M-Series loaders S450-S850 and T450-T870.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
