EF Logo

Volvo/Mack · MID 128 engine ECU - module, data link and power

Volvo/Mack Fault Code MID 128 SID 253 FMI 2

Engine ECU calibration memory checksum error

What does Volvo/Mack code MID 128 SID 253 FMI 2 mean?

The calibration memory in the engine control module has a checksum error, so engine parameters cannot be trusted. Urgency: stop now - shut down and fix before working on. Check first: check battery voltage and ground connections before touching the ECM.

FaultStopMID 128SID 253FMI 2Volvo/Mack · MID 128 engine ECU - module, data link and power
MID 128
Which control unit reports it
SID 253
Component at fault
FMI 2
Erratic or incorrect data

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check battery voltage and ground connections before touching the ECM

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Corrupted calibration data in the ECM
  • ECM software fault
  • Power interruption while the ECM was writing data

How it failed

You'll notice: Red stop lamp lights and the engine will not start because the calibration data cannot be trusted.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 253 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.