EF Logo

John Deere · Main controller (MCZ) - solenoids

John Deere Fault Code MCZ 11400.02

Pump 2 flow rate limit solenoid (SB), feedback abnormal

What does John Deere code MCZ 11400.02 mean?

The MCZ drives the pump 2 flow rate limit solenoid (sb) (Y20) but the current fed back does not match the command (feedback abnormal). Urgency: check soon - the machine may derate or limit a function. Check first: watch the Y20 current on the monitor service screen while changing engine speed and compare it with the commanded value.

FaultCheckMCZ11400.02John Deere · Main controller (MCZ) - solenoids
MCZ
Which controller reports it
11400
What is at fault
.02
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the Y20 current on the monitor service screen while changing engine speed and compare it with the commanded value

Then 4 more checks
Code shows hereFAULTMCZ11400.02

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Y20 coil resistance drifted or partly shorted, so the current does not follow the command
  • Intermittent contact in the Y20 plug, giving a current that jumps about
  • Contaminated or sticking spool in the pump 2 flow limit valve loading the coil unevenly
  • Y20 wires chafed against each other or the frame, touching only when the machine vibrates

How it failed

You'll notice: The pump 2 flow limit solenoid (Y20) is not doing what the MCZ commands, so pump 2 flow cannot be trimmed on request.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Pump flow, torque and displacement solenoids

Show the other 13 codes
All 22 Pump flow, torque and displacement solenoids codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11400.02 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.