EF Logo

John Deere · Engine control unit (ECU) - Cooling

John Deere Fault Code ECU 001639.01

Fan speed low

What does John Deere code ECU 001639.01 mean?

The ECU sees fan speed below the commanded value, with zero speed being the most severe case. The operator may see coolant or hydraulic oil temperature rising and the engine may derate. Urgency: check soon - the machine may derate or limit a function. Check first: look at the fan for blockage and spin it by hand with the engine off to feel for a seized bearing.

FaultCheckECU001639.01John Deere · Engine control unit (ECU) - Cooling
ECU
Which controller reports it
.01
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Look at the fan for blockage and spin it by hand with the engine off to feel for a seized bearing

Then 5 more checks
Code shows hereFAULTECU001639.01

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 6 done

Causes

  • Fan blades or drive jammed by debris or a seized bearing
  • Fan solenoid open or failed so the fan gets no drive
  • Fan speed sensor not reading
  • Low hydraulic flow to the fan motor

How it failed

You'll notice: The ECU sees fan speed below the commanded value, with zero speed being the most severe case.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Cooling fan control, reversing and speed

Show the other 14 codes
All 23 Cooling fan control, reversing and speed codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists ECU 001639.01 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.