JCB · Instrument cluster / MECU
JCB Fault Code B1002
Alternator not charging
What does JCB code B1002 mean?
The cluster or controller sees no charge from the alternator while the engine is running. The operator sees the charging warning lamp, and the battery will drain until the fault is fixed. Urgency: check soon - the machine may derate or limit a function. Check first: check the drive belt is present, tight and in good condition.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the drive belt is present, tight and in good condition
Then 5 more checksWhere this code shows
Switch the key on and note any warning lamp or fault icon on the cluster.
Checks
0 of 6 done
Causes
- Alternator failed and not producing charge
- Drive belt broken, slipping or off the pulley
- Loose or corroded alternator output cable
- Alternator excitation wire open
1 more causeFewer causes
- Cluster or controller sensing the charge signal wrongly
How it failed
You'll notice: The charging warning lamp is on and the battery will go flat if the machine keeps working with no charge.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, charging, warning lamps and service interval
- P0562System voltage lowShorted lowCheck soon
- P0563System voltage highShorted highCheck soon
- P0650Malfunction indicator lamp control circuit faultOtherInformation
- P0655Engine test indicator lamp malfunctionOtherInformation
- B1002Alternator not chargingOtherCheck soon
- C1025Battery voltage high faultShorted highCheck soon
- C1026Battery voltage low faultShorted lowCheck soon
- C1027Alternator voltage high faultShorted highCheck soon
- C1028Alternator voltage low faultShorted lowCheck soon
Show the other 4 codesHide the other codes
Related on Equipments Finder
Source
Partao JCB fault code list, page 1 (code table)
This source lists B1002 and its meaning. The guidance on this page is general, not taken from it.
The source covers: JCB machines with cluster.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
