J1939 · Fuel system
SPN 652 Fault Code
Engine injector, cylinder 2
What does SPN 652 mean?
The ECM drive circuit and injector solenoid for cylinder 2. The ECM fires it for each injection event and checks the circuit for opens, shorts and response. How urgent it is depends on the FMI after SPN 652 - pick it below. Check first: test each cylinder 2 injector wire to ground and to the other injector pins with both ends unplugged.
- SPN 652
- Engine injector, cylinder 2
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 652 - pick it below.
What should I check first?
Test each cylinder 2 injector wire to ground and to the other injector pins with both ends unplugged
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 652?
You'll notice: Cylinder 2 (the second cylinder from the front, between cylinders 1 and 3) is not being fired properly by its injector.
Find the number shown after SPN 652 on your display. FMI 5 has its own page with causes and checks.
- 3SPN 652 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, PACCAR MX-13, Volvo D13
- 4SPN 652 FMI 4: The ECM found cylinder 2 injector needle control valve operating below its minimum, or the circuit shorted to groundShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
- 5SPN 652 FMI 5: Current is below normal, or the circuit is openOpen circuitCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
- 6SPN 652 FMI 6: Cylinder 2 injector circuit is shorted, either to another injector pin or within the valveShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
- 7SPN 652 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerCummins ISX15, Mack MP8, Mack MP7, Volvo D13
- 8SPN 652 FMI 8: Abnormal frequency, pulse width or period of the signalErratic or implausibleMack MP8, Mack MP7, Volvo D13
- 13SPN 652 FMI 13: The value is out of calibrationPart or controllerMack MP8, Mack MP7, Volvo D13
- 31SPN 652 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
How urgent SPN 652 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Injector connector on cylinder 2 loose or corroded, interrupting the drive pulse
- Injector solenoid shorted between its turns, so the cylinder 2 current rises too fast
- Dirty or water-contaminated fuel scoring the cylinder 2 injector valve
- Cylinder 2 injector wiring chafed where it passes along the valve cover between cylinders 1 and 3, or pinched when the cover was refitted
1 more causeFewer causes
- Moisture or oil in the cylinder 2 connector after a valve cover gasket leak above it
Other Fuel system codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 652 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
