J1939 · Electrical
SPN 639 Fault Code
J1939 network 1 (primary vehicle data link)
What does SPN 639 mean?
The main CAN data link the ECM uses to exchange messages with the transmission, ABS, dash and other modules. How urgent it is depends on the FMI after SPN 639 - pick it below. Check first: measure the resistance across CAN high and CAN low at the diagnostic connector with the key off and compare it with the two-terminator figure.
- SPN 639
- J1939 network 1 (primary vehicle data link)
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 639 - pick it below.
What should I check first?
Measure the resistance across CAN high and CAN low at the diagnostic connector with the key off and compare it with the two-terminator figure
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 639?
You'll notice: The J1939 data link is faulty, so modules cannot share data.
Find the number shown after SPN 639 on your display. 2 of them have their own page with causes and checks.
- 2SPN 639 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleMack MP8, Mack MP7, Volvo D13
- 9SPN 639 FMI 9: Abnormal update rate: the signal or message is late or missingLost messageCummins ISX15
- 10SPN 639 FMI 10: A J1939 message is arriving at too high a rateErratic or implausiblePACCAR MX-13
- 11SPN 639 FMI 11: A hardware or software malfunction on a vehicle CAN busLost messagePACCAR MX-13
- 13SPN 639 FMI 13: The value is out of calibrationPart or controllerCummins ISX15
- 14SPN 639 FMI 14: The J1939 data link has failedLost messageDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 19SPN 639 FMI 19: A J1939 message carries data that is out of rangeLost messagePACCAR MX-13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 639 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Data link wiring damaged: CAN high or CAN low open, shorted to each other, to ground or to supply
- Terminating resistor missing or the wrong value at one end of the bus
- A faulty module dragging the whole bus down, so several others report lost communication
- Water or corrosion in a splice or a connector on the data link
Other Electrical codes
- SPN 677Starter relay driver circuit
- SPN 1136ECU internal temperature
- SPN 3597ECU power output supply voltage / power lost with key on
- SPN 158Ignition switch / keyswitch voltage
- SPN 167Charging system voltage
- SPN 168Battery / ECU supply voltage
- SPN 524Transmission message (ETC2) missing
- SPN 627Injector power supply
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 639 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
