EF Logo

J1939 · Electrical

SPN 639 FMI 9

J1939 data link abnormal update rate

What does SPN 639 FMI 9 mean?

Messages on the J1939 data link are arriving too slowly or irregularly. Modules may show gauge dropouts, intermittent derates and missing data. Urgency: check soon - the machine may derate or limit a function. Check first: wiggle the connectors and the harness while watching the data link status.

FaultCheckSPN 639FMI 9J1939 engine ECU
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Wiggle the connectors and the harness while watching the data link status

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Loose or wet connector causing intermittent contact
  • Bus overloaded by too many messages or a chattering module
  • A module failing and sending erratic messages
  • Corroded data link pins

How it failed

You'll notice: Messages on the J1939 data link arrive too slowly or irregularly, so gauges drop out, data goes missing and the engine may derate intermittently.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 639 with FMI 9. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.