J1939 · Fuel system
SPN 5358 Fault Code
Cylinder 1 smoothness control
What does SPN 5358 mean?
The engine-smoothness control for cylinder 1, which trims the fuel quantity to even out the cylinders. How urgent it is depends on the FMI after SPN 5358 - pick it below. Check first: run the injector balance or cylinder cutout test in the service tool and watch the cylinder 1 correction.
- SPN 5358
- Cylinder 1 smoothness control
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5358 - pick it below.
What should I check first?
Run the injector balance or cylinder cutout test in the service tool and watch the cylinder 1 correction
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5358?
You'll notice: Cylinder 1 is out of balance, so the engine may idle rough or knock and the ECM may limit power.
Find the number shown after SPN 5358 on your display.
- 16SPN 5358 FMI 16: Cylinder 1 smoothness control is above the normal range, moderately severe levelReal conditionDetroit DD15, Detroit DD13
- 18SPN 5358 FMI 18: Cylinder 1 smoothness control is below the normal range, moderately severe levelReal conditionDetroit DD15, Detroit DD13
Checks
0 of 5 done
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
How urgent SPN 5358 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Worn or leaking cylinder 1 injector
- Low compression on cylinder 1
- Air in the fuel
- Injector trim data wrong
Other Fuel system codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 5358 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
