EF Logo

J1939 · Aftertreatment - DPF

SPN 5298 Fault Code

Aftertreatment 1 diesel oxidation catalyst conversion efficiency

What does SPN 5298 mean?

How well the DOC converts hydrocarbons, judged from the temperature rise during dosing. It is used to detect an aged or damaged catalyst. How urgent it is depends on the FMI after SPN 5298 - pick it below. Check first: run a regeneration and compare the DOC inlet and outlet temperatures in the service tool.

FaultActiveSPN 5298FMI --J1939 engine ECU
SPN 5298
Aftertreatment 1 diesel oxidation catalyst conversion efficiency
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 5298 - pick it below.

What should I check first?

Run a regeneration and compare the DOC inlet and outlet temperatures in the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 5298?

You'll notice: The diesel oxidation catalyst is not converting as expected, so the temperature rise needed for regeneration is poor.

Find the number shown after SPN 5298 on your display.

  • 2SPN 5298 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 7SPN 5298 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerMack MP8, Mack MP7, Volvo D13
  • 17SPN 5298 FMI 17: Value is below the normal range, least severe levelReal conditionCummins ISX15
  • 18SPN 5298 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 5298 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • DOC contaminated by oil, fuel or sulphur and no longer lighting off
  • Hydrocarbon doser or in-cylinder dosing not delivering enough fuel
  • DOC inlet or outlet temperature sensor reading wrongly, so the temperature rise looks too small
  • Exhaust leak ahead of the DOC cooling the gas

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 5298 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.