J1939 · Aftertreatment - SCR/DEF
SPN 4364 FMI 31
SCR conversion efficiency condition exists
What does SPN 4364 FMI 31 mean?
The ECM reports that SCR conversion efficiency is low. It is a result of poor DEF, a clogged doser or a bad NOx sensor, and left alone it leads to inducement. Urgency: check soon - the machine may derate or limit a function. Check first: check the DEF quality with a refractometer and compare it with the DEF concentration limits.
- FMI 31
- Condition exists
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the DEF quality with a refractometer and compare it with the DEF concentration limits
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Poor DEF quality from dilution, age or contamination
- Doser blockage from crystals or a failing dosing valve
- NOx sensor reading wrongly, so efficiency looks low
- Catalyst ageing or contamination
How it failed
You'll notice: The ECM reports that SCR conversion efficiency is low, as a result of poor DEF, a clogged doser or a bad NOx sensor, and left alone it leads to inducement.
Real conditionRead from FMI 31: condition exists
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4364 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 4364 with FMI 31. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
