EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4340 Fault Code

Aftertreatment diesel exhaust fluid line heater 1

What does SPN 4340 mean?

The heater element on a DEF supply or return line that keeps it from freezing. The aftertreatment control switches it on in cold weather. How urgent it is depends on the FMI after SPN 4340 - pick it below. Check first: check the line heater fuse and relay, and listen for the relay clicking with the heater commanded.

FaultActiveSPN 4340FMI --J1939 engine ECU
SPN 4340
Aftertreatment diesel exhaust fluid line heater 1
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4340 - pick it below.

What should I check first?

Check the line heater fuse and relay, and listen for the relay clicking with the heater commanded

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4340?

You'll notice: A DEF line heater is not working, so the DEF supply line can freeze in cold weather.

Find the number shown after SPN 4340 on your display.

  • 3SPN 4340 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15
  • 4SPN 4340 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15
  • 5SPN 4340 FMI 5: Current is below normal, or the circuit is openOpen circuitCummins ISX15
  • 19SPN 4340 FMI 19: The DEF pipe heater state message arrived in error over CANLost messagePACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4340 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Heater element in the line failed open
  • Heater lead or plug open or shorted, such as a chafed wire at a bracket or corroded pins
  • Relay or fuse for the line heater faulty
  • Heater control sensor reading wrong, so the heater is switched off when the line is cold

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4340 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.