EF Logo

J1939 · Aftertreatment - DPF

SPN 3610 Fault Code

Aftertreatment 1 diesel particulate filter outlet pressure

What does SPN 3610 mean?

Exhaust pressure at the DPF outlet, read by a pressure sensor. The ECM uses it, with the inlet reading, to calculate pressure drop and soot load. How urgent it is depends on the FMI after SPN 3610 - pick it below. Check first: with the engine off, read the outlet pressure: it should be near ambient, and a full-scale value points to the circuit.

FaultActiveSPN 3610FMI --J1939 engine ECU
SPN 3610
Aftertreatment 1 diesel particulate filter outlet pressure
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3610 - pick it below.

What should I check first?

With the engine off, read the outlet pressure: it should be near ambient, and a full-scale value points to the circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3610?

You'll notice: The DPF outlet pressure is misread, so the ECM cannot judge the filter state or exhaust backpressure, and it can derate or block regeneration with a lamp on.

Find the number shown after SPN 3610 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3610 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Signal high or open: broken or backed-out pin, an open sensor return, or the signal shorted to the 5 V reference at the DPF outlet pressure sensor
  • Signal low or shorted: signal wire grounded, or the 5 V reference lost, so the DPF outlet pressure sensor reads at the bottom of its range
  • Real condition: exhaust restriction after the DPF, or a real leak at the tap
  • Real condition: damaged DPF can or clamp causing a false pressure reading
1 more cause
  • Sensor: condensate in the outlet hose making the reading bounce

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3610 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.