J1939 · Aftertreatment - SCR/DEF
SPN 3226 FMI 9
Outlet NOx sensor abnormal update rate
What does SPN 3226 FMI 9 mean?
The outlet NOx sensor is sending its data too slowly or at an irregular rate. The ECM may ignore the sensor and treat SCR performance as unverified. Urgency: check soon - the machine may derate or limit a function. Check first: check the supply voltage and ground at the downstream module under load, not only at rest.
- SPN 3226
- Aftertreatment 1 outlet NOx
- FMI 9
- Abnormal update rate
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the supply voltage and ground at the downstream module under load, not only at rest
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Downstream sensor module supply or ground weak from a corroded plug near the tailpipe
- CAN wiring from the tailpipe-end module to the ECM noisy or intermittent from road spray
- Downstream NOx sensor module failing and dropping messages
- Water or DEF crystals in the sensor module connector
How it failed
You'll notice: The downstream NOx sensor, after the SCR, sends data too slowly or irregularly, so the ECM may ignore it and treat SCR performance as unverified.
Lost messageRead from FMI 9: abnormal update rate
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3226 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3226 with FMI 9. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
