EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3226 FMI 10

Outlet NOx sensor abnormal rate of change

What does SPN 3226 FMI 10 mean?

The outlet NOx sensor reading is changing faster than the engine could produce. The ECM cannot trust it for SCR checks and may set a derate. Urgency: check soon - the machine may derate or limit a function. Check first: log the outlet NOx at a steady load and look for spikes that do not follow the intake NOx.

FaultCheckSPN 3226FMI 10J1939 engine ECU
FMI 10
Abnormal rate of change

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Log the outlet NOx at a steady load and look for spikes that do not follow the intake NOx

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Outlet NOx sensor element worn or soot-coated, so its output jumps with each pressure pulse
  • Sensor lead damaged near the tailpipe, giving intermittent signal changes as the exhaust flexes
  • Exhaust leak at the sensor boss pulling in air, which the sensor reads as sudden NOx changes
  • Poor contact in the sensor module plug from heat cycles

How it failed

You'll notice: The outlet NOx sensor value moves faster than the engine could really change it, so the ECM cannot trust the downstream reading for SCR checks and may set a derate and an efficiency fault.

Erratic or implausibleRead from FMI 10: abnormal rate of change

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 3226 with FMI 10. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.