J1939 · Aftertreatment - SCR/DEF
SPN 3226 FMI 4
Outlet NOx sensor circuit voltage low
What does SPN 3226 FMI 4 mean?
The outlet NOx sensor circuit reports a low or shorted-to-ground condition. NOx sensors talk over the data link with their own module, so the ECM cannot get a reading from the sensor. Urgency: check soon - the machine may derate or limit a function. Check first: read the outlet NOx value in the service tool; a flat zero or a not-available flag points to the circuit.
- SPN 3226
- Aftertreatment 1 outlet NOx
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the outlet NOx value in the service tool; a flat zero or a not-available flag points to the circuit
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Outlet sensor harness chafed on the tailpipe or SCR can bracket and shorted to ground
- NOx module near the tailpipe without power or ground from a corroded connector
- DEF crystals or condensate in the plug leaking between its pins
- Outlet NOx sensor failed internally, so it reports nothing
How it failed
You'll notice: The outlet NOx sensor circuit reads low or shorted to ground, so the ECM cannot judge SCR performance and may set an efficiency fault, a lamp and in time a derate.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3226 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3226 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
