EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3216 FMI 3

SCR inlet NOx sensor circuit high

What does SPN 3216 FMI 3 mean?

The intake NOx sensor circuit reports a high or shorted-to-supply condition. Urgency: check soon - the machine may derate or limit a function. Check first: read the inlet NOx value with the key on; a value pinned at the top of its range confirms the high reading.

FaultCheckSPN 3216FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the inlet NOx value with the key on; a value pinned at the top of its range confirms the high reading

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Sensor lead shorted to a supply wire where it runs alongside other exhaust sensor wiring
  • Open ground at the NOx module, which looks like a high reading
  • Corroded plug letting supply voltage reach the signal pins
  • Inlet NOx sensor failed high internally

How it failed

You'll notice: The inlet NOx sensor circuit reads high or shorted to supply, so the ECM treats the sensor as failed and cannot check SCR performance.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 3216 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.