J1939 · Aftertreatment - SCR/DEF
SPN 3216 FMI 10
Intake NOx sensor abnormal rate of change
What does SPN 3216 FMI 10 mean?
The intake NOx sensor reading is changing faster than the engine could produce. The ECM cannot trust it for SCR checks. Urgency: check soon - the machine may derate or limit a function. Check first: log the inlet NOx at a steady load and look for spikes with no matching engine change.
- SPN 3216
- Aftertreatment 1 intake NOx
- FMI 10
- Abnormal rate of change
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Log the inlet NOx at a steady load and look for spikes with no matching engine change
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Inlet NOx sensor failing or soot-coated, so its output jumps
- Loose plug at the sensor module, which breaks contact on rough ground
- Exhaust leak before the sensor mixing air into the sample
- Harness fault near the DPF outlet
How it failed
You'll notice: The inlet NOx sensor value changes faster than the engine could really change it, so the ECM cannot trust the engine-out NOx reading for the DEF dose and SCR checks.
Erratic or implausibleRead from FMI 10: abnormal rate of change
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3216 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3216 with FMI 10. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
