EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3216 FMI 9

Intake NOx sensor abnormal update rate

What does SPN 3216 FMI 9 mean?

The intake NOx sensor is sending its data too slowly or at an irregular rate. The ECM may ignore the sensor and SCR checks may fail. Urgency: check soon - the machine may derate or limit a function. Check first: log the upstream NOx update rate in the service tool through a load change and note when it stalls.

FaultCheckSPN 3216FMI 9J1939 engine ECU
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Log the upstream NOx update rate in the service tool through a load change and note when it stalls

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Module supply dipping under load at the plug beside the DPF outlet, so the sensor restarts and reports late
  • Upstream CAN branch with a loose splice or a chafed twisted pair, dropping messages
  • Sensor control module on the lead ageing from heat and resetting itself
  • Heat cycling at the DPF outlet loosening the module plug

How it failed

You'll notice: Data from the NOx sensor ahead of the SCR arrives late or in bursts, so the ECM may lose the engine-out NOx figure it uses to size the DEF dose.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 3216 with FMI 9. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.