J1939 · Aftertreatment - SCR/DEF
SPN 3216 FMI 4
Intake NOx sensor circuit voltage low
What does SPN 3216 FMI 4 mean?
The intake NOx sensor circuit reports a low or shorted-to-ground condition. NOx sensors talk over the data link with their own module, so the ECM cannot get a reading and cannot check SCR performance. Urgency: check soon - the machine may derate or limit a function. Check first: read the inlet NOx status and value in the service tool with the key on and again with the engine warm.
- SPN 3216
- Aftertreatment 1 intake NOx
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the inlet NOx status and value in the service tool with the key on and again with the engine warm
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Sensor harness at the upstream NOx sensor chafed against the exhaust pipe or a bracket and grounding out
- NOx sensor control module (on the sensor lead or pipe) without power, or its ground lost
- Water or DEF residue in the sensor plug bridging the signal or supply wires
- Inlet NOx sensor element failed internally, giving no output
How it failed
You'll notice: The inlet NOx sensor circuit reads low or shorted to ground, so the ECM has no engine-out NOx value.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3216 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3216 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
