EF Logo

J1939 · Air intake

SPN 2630 Fault Code

Engine charge air cooler outlet temperature

What does SPN 2630 mean?

Temperature of the air leaving the charge air cooler, read by a sensor in the charge pipe. The ECM uses it to check cooler performance and to correct boost and fuelling. How urgent it is depends on the FMI after SPN 2630 - pick it below. Check first: compare the outlet temperature with the intake manifold temperature after a cold soak; they should be close.

FaultActiveSPN 2630FMI --J1939 engine ECU
SPN 2630
Engine charge air cooler outlet temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 2630 - pick it below.

What should I check first?

Compare the outlet temperature with the intake manifold temperature after a cold soak; they should be close

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 2630?

You'll notice: Charge air cooler outlet temperature is misread, so the ECM may overcorrect boost and fuelling.

Find the number shown after SPN 2630 on your display.

  • 2SPN 2630 FMI 2: Data is erratic, intermittent or incorrectErratic or implausiblePACCAR MX-13
  • 3SPN 2630 FMI 3: Charge air cooler outlet temperature circuit reads highShorted highDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
  • 4SPN 2630 FMI 4: Charge air cooler outlet temperature circuit reads lowShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
  • 10SPN 2630 FMI 10: The value is changing at an abnormal rateErratic or implausiblePACCAR MX-13
  • 14SPN 2630 FMI 14: Charge air cooler outlet temperature sensor signal is not plausibleErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 16SPN 2630 FMI 16: Charge air cooler outlet temperature is too high or its performance monitor failedReal conditionDetroit DD15, PACCAR MX-13

Checks

0 of 5 done

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

How urgent SPN 2630 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Circuit (reads cold): open wire or pin backed out at the cooler outlet sensor, which reads as a very cold temperature
  • Circuit (reads hot): signal wire shorted to ground or a shorted sensor element
  • Charge air cooler fouled with debris or oil, so outlet temperature is really high
  • Sensor loose in the outlet pipe or its seal damaged

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list names SPN 2630 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.