J1939 · Engine speed/timing
SPN 188 Fault Code
Engine speed at idle, point 1
What does SPN 188 mean?
The low idle speed set point stored in the ECM's engine configuration. It defines the speed the governor holds at idle. How urgent it is depends on the FMI after SPN 188 - pick it below. Check first: compare the actual idle speed with the target and watch the pedal and PTO demand in the service tool.
- SPN 188
- Engine speed at idle, point 1
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 188 - pick it below.
What should I check first?
Compare the actual idle speed with the target and watch the pedal and PTO demand in the service tool
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 188?
You'll notice: Idle speed does not match the target, so the engine idles too high, too low or hunts.
Find the number shown after SPN 188 on your display.
- 0SPN 188 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 1SPN 188 FMI 1: Value is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 2SPN 188 FMI 2: Actual idle speed differs from the target idle speedErratic or implausiblePACCAR MX-13
- 16SPN 188 FMI 16: Engine idle speed is below the normal range, moderately severeReal conditionCummins ISX15
- 18SPN 188 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15
- 31SPN 188 FMI 31: Idle speed is higher than the target idle speedReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 188 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Air or fuel delivery problem making the engine unable to hold the target idle
- Throttle or speed demand signal wrong: pedal, PTO or cruise input sending an incorrect command
- Engine load from an auxiliary such as an air conditioning compressor or hydraulic pump at idle
- Crank or cam sensor signal faults causing speed measurement errors
Other Engine speed/timing codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 188 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
