EF Logo

J1939 · Engine speed/timing

SPN 1323 Fault Code

Engine misfire, cylinder 1

What does SPN 1323 mean?

A misfire detection for cylinder 1, derived by the ECM from crankshaft speed variation. It is used to flag a cylinder that is not contributing normal power. How urgent it is depends on the FMI after SPN 1323 - pick it below. Check first: read the cylinder 1 misfire counter or balance value in the service tool and compare it with the other cylinders.

FaultActiveSPN 1323FMI --J1939 engine ECU
SPN 1323
Engine misfire, cylinder 1
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 1323 - pick it below.

What should I check first?

Read the cylinder 1 misfire counter or balance value in the service tool and compare it with the other cylinders

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 1323?

You'll notice: Cylinder 1 (the front cylinder at the gear-train end of the engine) is misfiring.

Find the number shown after SPN 1323 on your display.

  • 1SPN 1323 FMI 1: Cylinder 1 is contributing too little, or is misfiringReal conditionPACCAR MX-13
  • 10SPN 1323 FMI 10: Cylinder 1 misfire rate is above 5 percentErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 31SPN 1323 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

How urgent SPN 1323 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Fuel delivery fault on cylinder 1: injector worn, leaking or sticking, so combustion is weak
  • Poor compression on cylinder 1: worn rings, a burnt valve or a leaking head gasket
  • Injector wiring or connector fault on cylinder 1 causing an intermittent drive
  • Cylinder 1 injector, valve train or compression weaker than its neighbour cylinder 2, which shows in the contribution test

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 1323 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.