J1939 · Engine speed/timing
SPN 637 Fault Code
Engine speed / position sensor (crankshaft)
What does SPN 637 mean?
The crankshaft pickup that gives the ECM engine speed and position for injection timing. Engine makers label this input differently; the Mack, Volvo and Cummins lists here call it the crankshaft sensor. How urgent it is depends on the FMI after SPN 637 - pick it below. Check first: watch the engine speed signal while cranking in the service tool.
- SPN 637
- Engine speed / position sensor (crankshaft)
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 637 - pick it below.
What should I check first?
Watch the engine speed signal while cranking in the service tool
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 637?
You'll notice: The crankshaft speed or position signal is erratic or missing, so the engine may stall, run rough or not start.
Find the number shown after SPN 637 on your display.
- 2SPN 637 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleMack MP8, Mack MP7, Volvo D13
- 3SPN 637 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, Volvo D13
- 8SPN 637 FMI 8: Abnormal frequency, pulse width or period of the signalErratic or implausibleMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 637 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Sensor wiring faulty: open, shorted or chafed between the sensor and the ECM
- Sensor dirty with metal debris or loose in its housing
- Tone wheel damage or loose gear causing a distorted signal
- Oil or coolant in the sensor connector
Other Engine speed/timing codes
Source
Mack MP8 2010-2013 fault code list (Diesel Laptops)
This list names SPN 637 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Mack MP7 and MP8; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
