EF Logo

J1939 · Engine speed/timing

SPN 1322 Fault Code

Engine misfire, multiple cylinders

What does SPN 1322 mean?

A misfire detection for more than one cylinder, derived by the ECM from crankshaft speed variation. It flags that several cylinders are not delivering normal power. How urgent it is depends on the FMI after SPN 1322 - pick it below. Check first: read the injector balance or cylinder contribution values to see which cylinders are weak.

FaultActiveSPN 1322FMI --J1939 engine ECU
SPN 1322
Engine misfire, multiple cylinders
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 1322 - pick it below.

What should I check first?

Read the injector balance or cylinder contribution values to see which cylinders are weak

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 1322?

You'll notice: The ECM sees misfire across several cylinders, so the engine runs rough, shakes at idle, lacks power and may smoke.

Find the number shown after SPN 1322 on your display.

  • 8SPN 1322 FMI 8: Abnormal frequency, pulse width or period of the signalErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 9SPN 1322 FMI 9: Misfire detected on alternating cylindersLost messageDetroit DD13 Gen 5, Detroit DD15 Gen 5
  • 10SPN 1322 FMI 10: Simultaneous misfire detected on several cylindersErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 11SPN 1322 FMI 11: Misfire on alternating cylinders detected, including in asymmetry modeOtherDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 12SPN 1322 FMI 12: Simultaneous misfire detected on multiple cylindersPart or controllerDetroit DD13 Gen 5, Detroit DD15 Gen 5
  • 31SPN 1322 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

How urgent SPN 1322 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Common fuel problem: fuel filter restricted, air in the fuel or low rail pressure affecting several cylinders at once
  • Several worn injectors or a shared injector supply or ground fault
  • Air or compression problem: restricted air filter, boost leak or a weak valve train on more than one cylinder
  • Crank or cam sensor signal fault upsetting the misfire detection for all cylinders

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 1322 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.