EF Logo

J1939 · Fuel system

SPN 164 Fault Code

Engine injection control pressure

What does SPN 164 mean?

Fuel rail pressure used for injection control, read by the rail pressure sensor. The ECM compares it with its target and regulates the high-pressure pump to match. How urgent it is depends on the FMI after SPN 164 - pick it below. Check first: compare the injection control pressure with the commanded pressure at cranking and under load.

FaultActiveSPN 164FMI --J1939 engine ECU
SPN 164
Engine injection control pressure
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 164 - pick it below.

What should I check first?

Compare the injection control pressure with the commanded pressure at cranking and under load

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 164?

You'll notice: The ECM cannot trust the injection control pressure on a Detroit-style rail, so it limits fuelling to protect the system.

Find the number shown after SPN 164 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

How urgent SPN 164 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Sensor circuit (FMI 3/4): signal wire open, shorted to the supply or to ground between the rail pressure sensor and the ECM
  • Pressure error (FMI 15): actual rail pressure differs from the target by more than the limit under load, usually from supply or pump problems
  • Erratic or drifting reading (FMI 2/20/21): sensor drifting high or low against the true pressure or a loose plug
  • Open circuit (FMI 5): sensor plug off or pin backed out at the rail

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list names SPN 164 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.