EF Logo

J1939 · Fuel system

SPN 164 FMI 3

Rail pressure sensor circuit high (open)

What does SPN 164 FMI 3 mean?

The rail pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: stop now - shut down and fix before working on. Check first: key on, engine off: read the injection control pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return.

FaultStopSPN 164FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Key on, engine off: read the injection control pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Open signal wire between the injection control pressure sensor plug and the ECM, so the input floats to the top of its range
  • Open return, or the signal wire touching the 5 V reference or a battery-voltage circuit
  • Sensor plug unseated after rail or injector work, leaving the signal open
  • Signal wire shorted to the supply in the rail harness
1 more cause
  • Sensor failed internally after fuel contamination

How it failed

You'll notice: The ECM cannot read injection pressure, so it cannot control the high-pressure pump and the engine may stall, lose power or not start, with the stop lamp on.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 164 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.