J1939 · Engine speed/timing
SPN 1569 Fault Code
Engine protection system torque derate
What does SPN 1569 mean?
The ECM's engine protection function that limits torque when a protected condition is active, such as high coolant temperature or low oil pressure. The derate is reported to the dash and other modules. How urgent it is depends on the FMI after SPN 1569 - pick it below. Check first: read all active and stored fault codes and fix the first one, as the derate clears with its cause.
- SPN 1569
- Engine protection system torque derate
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 1569 - pick it below.
What should I check first?
Read all active and stored fault codes and fix the first one, as the derate clears with its cause
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 1569?
You'll notice: The ECM is cutting engine torque to protect the engine, so power drops and a protection lamp comes on.
Find the number shown after SPN 1569 on your display. FMI 31 has its own page with causes and checks.
- 11SPN 1569 FMI 11: Engine protection has activated, with a warning or power derateOtherPACCAR MX-13
- 15SPN 1569 FMI 15: Value is above the normal range, least severe levelReal conditionCummins ISX15
- 31SPN 1569 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 1569 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Another active protection fault such as low oil pressure, high coolant temperature or low fuel pressure
- Aftertreatment fault such as DEF level or quality, SCR efficiency or DPF soot load leading to a derate
- Sensor fault making a protection limit look reached when it is not
- Operator-caused condition such as overloading or running with a blocked cooler
Other Engine speed/timing codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 1569 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
