J1939 · Engine speed/timing
SPN 1326 Fault Code
Engine misfire, cylinder 4
What does SPN 1326 mean?
A misfire detection for cylinder 4, derived by the ECM from crankshaft speed variation. It is used to flag a cylinder that is not contributing normal power. How urgent it is depends on the FMI after SPN 1326 - pick it below. Check first: read the cylinder 4 misfire counter or balance value in the service tool and compare it with the other cylinders.
- SPN 1326
- Engine misfire, cylinder 4
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 1326 - pick it below.
What should I check first?
Read the cylinder 4 misfire counter or balance value in the service tool and compare it with the other cylinders
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 1326?
You'll notice: Cylinder 4 (the fourth cylinder from the front, just behind the middle of the engine) is misfiring.
Find the number shown after SPN 1326 on your display.
- 10SPN 1326 FMI 10: Cylinder 4 misfire rate is above 5 percentErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 11SPN 1326 FMI 11: Cylinder 4 misfire detectedOtherDetroit DD13 Gen 5, Detroit DD15 Gen 5, PACCAR MX-13
- 31SPN 1326 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
How urgent SPN 1326 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Fuel delivery fault on cylinder 4: injector worn, leaking or sticking, so combustion is weak
- Valve lash out of adjustment or a bent pushrod on cylinder 4, so a valve does not seat or open fully
- Wrong or missing injector trim code for cylinder 4 after a replacement
- Cylinder 4 injector or valve train weaker than cylinders 3 and 5 either side of it
Other Engine speed/timing codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 1326 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
