J1939 · Lubrication
SPN 100 FMI 3
Oil pressure sensor voltage high
What does SPN 100 FMI 3 mean?
The oil pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return.
- SPN 100
- Engine oil pressure
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Open signal wire between the oil pressure sensor plug and the ECM, so the input floats to the top of its range
- Open return, or the signal wire touching the 5 V reference or a battery-voltage circuit
- Wrong replacement sensor with a different output range from the one the ECM expects
- Oil wicking up the sensor wires and into the connector, bridging the signal to the supply
1 more causeFewer causes
- Sensor body cracked or its thread leaking oil onto the plug
How it failed
You'll notice: The oil pressure gauge reads zero, sticks at the top or flickers and the warning lamp may come on.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 100 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 100 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
