J1939 · Lubrication
SPN 100 FMI 1
Oil pressure low, most severe
What does SPN 100 FMI 1 mean?
Oil pressure is far below the safe minimum, the most severe low-pressure level. The ECM may shut the engine down to avoid bearing damage, so stop and check. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level and condition on the dipstick.
- SPN 100
- Engine oil pressure
- FMI 1
- Data below normal, most severe
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Stop the engine and check the oil level and condition on the dipstick
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Oil level very low or the oil badly diluted with fuel or coolant
- Oil pump worn or its relief valve stuck open
- Bearings badly worn, letting oil escape
- Pickup tube blocked or loose, so the pump draws air
How it failed
You'll notice: Oil pressure is far below the safe minimum, the most severe low level, so the ECM can shut the engine down to save the bearings.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 100 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 100 with FMI 1. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
