EF Logo

Hyundai · Transmission TCU codes (hex)

Hyundai Fault Code F6

TCU clutch adjustment data lost

What does Hyundai code F6 mean?

The TCU could not read the stored clutch adjustment data after a TCU, valve block or transmission replacement. Urgency: check soon - the machine may derate or limit a function. Check first: run the AEB cycle with the shifter in neutral, engine at idle, parking brake applied and the transmission at working temperature.

FaultCheckF6Hyundai · Transmission TCU codes (hex)

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Run the AEB cycle with the shifter in neutral, engine at idle, parking brake applied and the transmission at working temperature

Then 3 more checks
Code shows hereFAULTF6

Where this code shows

Turn the key on and open the fault code or diagnosis menu on the cluster.

Checks

0 of 4 done

Causes

  • Transmission, valve block or TCU replaced without running AEB
  • Stored clutch data lost
  • EEPROM write failed during a previous AEB

How it failed

You'll notice: The display shows F6 and the transmission uses default clutch filling values until AEB is run.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: TCU power supply, joystick, display and internal faults

Source

Hyundai HL757-9 wheel loader service manual, Structure and function, group 4 Fault code (machine HCESPN table pp. 3-19 to 3-21, TCU table pp. 3-23 to 3-41)

This source lists F6 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Hyundai HL757-9 wheel loader (manual covers the MCU machine table and the TCU transmission table).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.