Genie · Engine faults (Deutz TD 2.9, SPN/FMI)
Genie Fault Code SPN 157 / FMI 3
Rail pressure sensor signal high
What does Genie code SPN 157 / FMI 3 mean?
The rail pressure sensor signal is too high. The ECU may limit power or stop the engine, and the engine fault lamp comes on. Urgency: check soon - the machine may derate or limit a function. Check first: inspect the rail pressure sensor plug on the fuel rail for water and corrosion.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Inspect the rail pressure sensor plug on the fuel rail for water and corrosion.
Then 3 more checksWhere this code shows
Scissors: read the code on the platform LED display or the ground control LCD.
Checks
0 of 4 done
Causes
- Rail pressure sensor wire shorted to the 5 V supply at the rail connector
- Rail pressure sensor failed high
- Real over-pressure in the rail from a stuck pressure control valve
How it failed
You'll notice: The ECU may limit power or stop the engine and the engine fault lamp comes on because the high pressure rail sensor reads too high.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Deutz engine faults (SPN/FMI)
- SPN 94 / FMI 1Low fuel pressureReal conditionStop now
- SPN 97 / FMI 12Water in fuel prefilterPart or controllerCheck soon
- SPN 100 / FMI 1Low oil pressureReal conditionStop now
- SPN 110 / FMI 0High coolant temperatureReal conditionStop now
- SPN 111 / FMI 1Coolant level too lowReal conditionStop now
- SPN 157 / FMI 3Rail pressure sensor signal highShorted highCheck soon
- SPN 190 / FMI 12Crankshaft speed sensor: no signalPart or controllerStop now
- SPN 523633 / FMI 11NOx conversion rate insufficientLost messageCheck soon
- SPN 524025 / FMI 14Particulate filter regeneration not successfulOtherCheck soon
Related on Equipments Finder
Source
Genie GTH-5519 (Deutz Tier 4i) Service and Repair Manual 1272852, Section 4 Fault Codes
This source lists SPN 157 / FMI 3 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Genie GTH-5519 telehandler, Deutz Tier 4i (from serial GTH5514B-101).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
