EF Logo

Genie · Engine faults (Deutz TD 2.9, SPN/FMI)

Genie Fault Code SPN 100 / FMI 1

Low oil pressure

What does Genie code SPN 100 / FMI 1 mean?

The engine oil pressure is below the warning or shut-off threshold. The engine derates or shuts down and the oil pressure lamp comes on. Urgency: stop now - shut down and fix before working on. Check first: check the oil level on the dipstick and top up with the specified oil if low; do not run the engine if the level is below the mark.

FaultStopSPN 100FMI 1Genie · Engine faults (Deutz TD 2.9, SPN/FMI)

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the oil level on the dipstick and top up with the specified oil if low; do not run the engine if the level is below the mark.

Then 4 more checks
Stored in the engine ECUFAULTSPN 100FMI 1

Where this code shows

Scissors: read the code on the platform LED display or the ground control LCD.

Checks

0 of 5 done

Causes

  • Low oil level or wrong oil grade
  • Worn oil pump or bearings
  • Oil pressure sensor or wiring fault
  • Blocked oil filter or leaking oil cooler

How it failed

You'll notice: The engine derates or shuts down and the oil pressure lamp lights because oil pressure is below the threshold.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Deutz engine faults (SPN/FMI)

Source

Genie GTH-5519 (Deutz Tier 4i) Service and Repair Manual 1272852, Section 4 Fault Codes

This source lists SPN 100 / FMI 1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Genie GTH-5519 telehandler, Deutz Tier 4i (from serial GTH5514B-101).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.