EF Logo

Genie · Battery charger codes

Genie Fault Code E‑0‑0‑4

Charger: defective battery

What does Genie code E-0-0-4 mean?

The charger could not trickle-charge the battery pack up to the minimum voltage, so the pack is judged defective. The charger stops until the pack is repaired. Urgency: check soon - the machine may derate or limit a function. Check first: check the voltage of each battery to find a dead or shorted cell.

FaultCheckE-0-0-4Genie · Battery charger codes

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the voltage of each battery to find a dead or shorted cell.

Then 3 more checks
Code shows hereFAULTE-0-0-4

Where this code shows

Scissors: read the code on the platform LED display or the ground control LCD.

Checks

0 of 4 done

Causes

  • Failed or damaged battery
  • Loose or corroded connections
  • Shorted cell in the pack
  • Deeply discharged pack that cannot recover

How it failed

You'll notice: The charger refuses to charge because it could not trickle the pack up to minimum voltage, so the pack is judged defective.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Charger battery, supply, temperature and connection errors

Source

Genie GS-1530/1930/2032/2632 etc. Service and Repair Manual 1272217GT (Rev E1), Section 4 Diagnostics

This source lists E-0-0-4 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Genie GS slab scissors with the on-board charger.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.