Detroit · Cooling system
Detroit Fault Code SPN 111 FMI 1
Coolant Level Very Low
What does Detroit code SPN 111 FMI 1 mean?
The MCM sees the coolant level very low in the surge tank. This is a protection fault, because low coolant can overheat and damage the engine. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the coolant level when it is cold, not when it is hot.
- SPN 111
- Engine coolant level
- FMI 1
- Data below normal, most severe
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Stop the engine and check the coolant level when it is cold, not when it is hot.
Then 3 more checksWhere to read it
Connect a Detroit-capable diagnostic tool (Diagnostic Link or a compatible scan tool) to the vehicle diagnostic socket.
Checks
0 of 4 done
Causes
- Coolant leak from a hose, the radiator or the water pump
- Air in the system
- Coolant level sensor fault
How it failed
You'll notice: A low coolant warning, the stop-engine lamp and a possible engine shutdown.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Coolant temperature, level and thermostat
6 other codes on this part are also real condition (SPN 110 FMI 0, SPN 110 FMI 16, SPN 110 FMI 18, SPN 111 FMI 18 and more). When they show together, start at the wiring and connector they share.
- SPN 110 FMI 9Coolant Temperature Signal Not Available via Controller Area Network (CAN)Lost messageCheck soon
- SPN 110 FMI 16Coolant Temperature High AlarmReal conditionCheck soon
- SPN 110 FMI 18Failed Coolant Thermostat (Coolant Heat Up Too Slow Compared to Modeled Coolant Temperature)Real conditionCheck soon
- SPN 110 FMI 20Engine Coolant Outlet Temperature Sensor General Temperature Plausibility ErrorErratic or implausibleCheck soon
- SPN 111 FMI 1Coolant Level Very LowReal conditionStop now
- SPN 111 FMI 3Coolant Level Circuit Failed HighShorted highCheck soon
- SPN 111 FMI 4Coolant level Sensor Circuit Failed LowShorted lowCheck soon
- SPN 111 FMI 14Coolant Level Signal Erratic DataErratic or implausibleCheck soon
- SPN 111 FMI 18Coolant Level LowReal conditionCheck soon
Show the other 11 codesHide the other codes
- SPN 110 FMI 0Coolant Temperature HighReal conditionStop now
- SPN 110 FMI 3Engine Coolant Outlet Temperature Circuit Short to Voltage or OpenShorted highCheck soon
- SPN 110 FMI 4Engine Coolant Outlet Temperature Circuit Failed LowShorted lowCheck soon
- SPN 1637 FMI 2Coolant Out Temperature Signal Not PlausibleErratic or implausibleCheck soon
- SPN 1659 FMI 7Thermostat Cool DownPart or controllerCheck soon
- SPN 1659 FMI 17Coolant Temperature Low Pre FailReal conditionCheck soon
- SPN 1659 FMI 31Thermostat Cool DownReal conditionCheck soon
- SPN 4193 FMI 3Engine Coolant Inlet Temperature Circuit Failed HighShorted highCheck soon
- SPN 4193 FMI 4Engine Coolant Inlet Temperature Circuit Failed LowShorted lowCheck soon
- SPN 4193 FMI 14Engine Coolant Inlet Temperature Circuit Failed HighOtherCheck soon
- SPN 4193 FMI 20Coolant Inlet Temperature Signal Not PlausibleErratic or implausibleCheck soon
Other Detroit codes: Cooling system
Related on Equipments Finder
Source
Detroit Diesel DD15 Gen 5 (2023) Fault Codes List, Diesel Repair (SPN/FMI with Detroit descriptions)
This source lists SPN 111 FMI 1 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, DD15, DD16 (GHG14/GHG17, Gen 5) with MCM, ACM and CPC5.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
